Exhaust Tomos A3 / A35 Tecno Bullet blank aluminium silencer

Exhaust Tomos A3 / A35 28mm Tecno Bullet blank with aluminium silencer

• With aluminium silencer
• Tomos A3 / A35 / Standard / Quadro / Flexer / Luxe / Wizz'rd / Taxxity / Califone / Limited / various models
• Exhaust mounting to frame Euro1 model, do you have a frame mounting with 2 holes? Order a Euro2 exhaust bracket along (see related products)
  

Note:

• The 'dent' in the silencer is not a dent, this is normal!
• Please note that the exhaust is bare i.e. raw untreated steel. The material may therefore contain small scratches/spots
  

Tips:

• Mount the exhaust with a silent rubber. When there is a lot of vibration, the rivets in the aluminium silencer can loose or the silencer can break. No warranty!
  
• Use our long brass M6 nuts in combination with hardened studs (see related products). This so you can easily and fully tighten the exhaust flange. Brass is also softer than steel, so it will not seize.
• Always use a new exhaust gasket when fitting an exhaust

When using all exhausts, black painted, chrome and blanc exhausts, heat build-up at the exhaust manifold can cause the following:

• At black outlets the paint can dissolve a little.
• Chrome and blanc exhaust manifolds may discolour

If the nozzle is too small or if the ignition is set incorrectly, the exhaust port becomes very hot and discoloring and dissolve of the paint on the exhaust manifold will occur faster than a perfectly adjusted engine. We give no guarantee on discoloration or solving of the paint on the exhaust manifold!

Dimensions:

• A: 280mm
• B: 610mm
• C: 24mm
• D: 28mm
• E: 5mm